Change the number to select the best match for your sensor from the list.To be honest, I dont mess with the firmware that much, and if it wasnt for the configuration file from my last version, I would struggle to remember what sort of configuration I would need to set in the latest firmware version.The notes will focus on the Marlin firmware v1 and will include setting up a click encoder and LCD panel.But before going straight into getting the Marlin firmware configured, Ill first quickly introduce you to a handy tool called WinMerge.
Using this guide with the firmware it is based on will give you the smoothest 3d printer set-up experience. ![]() This will help to keep track and note all the changes made to the files that you might want to transfer to a newer firmware version. Comparing 3d printer firmware folders will allow you to quickly spot which files that have been edited. The notes will be biased towards the Ramps 1.3 board, but the note will still be valid for any Marlin firmware compatible board. ![]() I dont guarantee that the information in this Marlin firmware guide is accurate, however, if you spot any mistakes please leave a comment at the end of the post. The Marlin firmware guide is likely to be updated to improve the information where necessary after publishing. In the following notes, to edit the firmware, Ill be using line numbers to reference the location of the code in the Marlin firmware configuration file. Although there is no line numbering in the IDE editor window, you will see the line number at the bottom left of the IDE showing the current cursor position. Just move the cursor to any line with the mouse to update the line number. Use WinMerge to compare the changes to a clean non-edited version of Configuration.h for final review before uploading to the 3d printer motherboard. Two common baud rate options are defined with one, preceded with two forward slashes (), commented out to disable. The default enabled option, 250000 baud rate, works well when used with PrintrunPronterface and RepSnapper software. The code snippet above defines the Ramps 1.3 as the motherboard, you can select a board just by changing the number to any board thats on the list. The Marlin firmware will manage circuit board pin assignments to match the motherboard you have selected. Pin assignment details for each motherboard type can be found in the pins.h file of the Marlin firmware. Basically all we need to do is select a temperature sensor type for each of the sensors installed on the 3d printer. ![]() The code snippet above is setting up the 3d printer that features one hot end and a heated build platform. The temperature sensor selected for both features is 100k thermistor.
0 Comments
Leave a Reply. |
Details
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |